1INSTALLATIONINSTRUCTIONSSECURITY SYSTEMUPGRADEFORESTERP/N: H7110FS400Kit Contents:1 Security Control Module w/Integral Bracket1 Starter Interrupt Rel
2Figure 1Figure 2Figure 3A. Pre-Installation NotesB. Security Module Installation1. Vehicle Preparationa. Lower the driver’s side window to avoid inad
3Figure 4Figure 5Figure 65. Remove and retain for reinstallation, the black M8bolt indicated by the arrow “A” in Figure 4. Loosenthe M8 bolt indicated
4Figure 79. Remove one plastic screw and two metal screwsindicated by the arrows in Figure 7, then remove thelower dash panel by pulling the upper sid
5C. Starter Interrupt Installation1. Locate the starter interrupt 6-pin (white housing)connector, which is located next to the right side ofthe fuse b
6D. Prior to System Test1. Reconnect negative battery terminal.E. System Test1. Exit the vehicle and close all doors.2. Depress the LOCK/ARM button on
75. Depress the UNLOCK/DISARM button and the driver’s door should unlock.6. Open the driver’s door and then depress and hold the UNLOCK/DISARM on the
8I. Shock Sensor Adjustment-ONLY IF REQUIREDThe factory has preset the sensitivity of the shock sensor at the time of manufacture. Under normalcircums
Kommentare zu diesen Handbüchern