Subaru 2007 Tribeca Bedienungsanleitung PDF herunterladen (Seite 222)

Interior equipment 6-19

6

– CONTINUED –

trol System and your garage door opener

should activate when the HomeLink

®

but-

ton is pressed.

 Programming for entrance

gates and garage door open-

ers in Canada

1. Unplug the motor of the entrance gate

or garage door opener from the outlet.

2. Press and hold the two outside buttons

until the HomeLink

®

indicator light begins

to flash (after 20 seconds). Release both

buttons.

N

O

TE

If any of the HomeLink

®

buttons are al-

ready programmed for other devices,

skip step 2 because it clears the mem-

ory of all three buttons.

3. Hold the end of the entrance gate’s/ga-

rage door opener’s hand-held transmitter

between 1 and 3 inches (25 and 76 mm)

away from the HomeLink

®

buttons on the

driver’s sun visor, keeping the indicator

light in view.

4. Press and hold the desired HomeLink

®

button.

5. Press and release (“cycle”) the hand-

held transmitter button every two seconds

until step 6 is complete.

6. When the indicator light flashes slowly

and then rapidly after several seconds, re-

lease both buttons.

7. Plug the motor of the entrance gate/ga-

rage door opener to the outlet.

8. Test your entrance gate/garage door

opener by pressing the programmed

HomeLink

®

button.

 Programming other devices

To program other devices such as door

locks, home lighting and security systems,

contact HomeLink at www.homelink.com

or call 1-800-355-3515.

 Operating the HomeLink

®

Wireless Control System

Once programmed, the HomeLink

®

Wire-

less Control System can be used to re-

mote-control the devices to which its but-

tons are programmed. To activate a de-

vice, simply press the appropriate button.

The indicator light illuminates, indicating

that the signal is being transmitted.

 Reprogramming a single

HomeLink

®

button

1. Press and hold the HomeLink

®

button

you wish to reprogram. DO NOT release

the button until step 4 has been complet-

ed.

2. When the HomeLink

®

indicator light

begins to flash slowly (after 20 seconds),

position the hand-held transmitter of the

device for which you wish to program the

button at 1 to 3 inches (25 to 76 mm) away

600430

600434

A3120BE-B.book 19 ページ２００６年５月３０日　火曜日　午前９時３２分

1 2 ... 217 218 219 220 221 222 223 224 225 226 227 ... 400 401

Kommentare zu diesen Handbüchern

Keine Kommentare