Subaru 2007 Tribeca Bedienungsanleitung PDF herunterladen (Seite 238)

Starting and operating 7-9

7

– CONTINUED –

 Starting your vehicle

The remote control start system is activat-

ed by pressing the “ ” button twice

within 3 seconds on your remote control

transmitter. The system will check certain

pre-conditions before starting, and if all

safety parameters are correct, the engine

will start within 5 seconds. While the vehi-

cle is operating via remote engine start,

the vehicle's power window features will

be disabled. Also, the system has a timer

and will shut down after 15 minutes if you

do not operate the vehicle. Press and hold

the “ ” button for 2 seconds again to

turn the vehicle off. If the vehicle's starter

cranks but does not start or starts and

stalls, the remote engine start system will

power off then attempt to start the vehicle

an additional four times. If the vehicle fails

to start after the additional attempts, the

remote engine start system will abort and

return to a non activated state.

 Remote start safety features

For safety and security reasons, the sys-

tem will fail to start and beep the horn

twice or shut down the engine during re-

mote start operation if any of the following

occur:

y The brake pedal is pressed before the

vehicle ignition switch is turned “on”

y The key was already in the ignition

switch

y The engine hood is opened

y The vehicle’s engine idle speed has

reached a level over 3,000 RPM

y The alarm is triggered by opening a

door or the rear gate.

N

O

TE

y The security indicator light on the

dashboard will stop flashing while un-

der remote engine start operation, but

the vehicle is still protected.

y If the vehicle is entered during re-

mote engine start operation, the sys-

tem will not record entry in the alarm

history.

 Entering the vehicle while it is

running via remote start

1. Unlock the vehicle doors using the key-

less entry system. If the vehicle’s doors

are unlocked manually using the key, the

vehicle’s alarm system will trigger and the

remote engine start system will turn off. In-

serting the key into the ignition switch and

turning it to the “ON” position or pressing

the unlock button “ ” on the remote

keyless entry transmitter will disarm the

alarm system. Refer to the “Alarm system”

section in chapter 2.

2. Enter the vehicle. Do not press the

brake pedal.

3. Insert the key into the ignition switch

and turn to the “ON” position. If the ignition

switch is accidentally turned to the

“START” position, the system’s “starter

anti-grind” feature will prevent the starter

from re-cranking.

4. Press the brake pedal. The remote

starter disengages, the vehicle’s power

window features are re-enabled and the

vehicle will operate normally.

 Entering the vehicle follow-

ing remote engine start shut-

down

An alarm trigger may occur if the vehicle is

opened by the remote keyless entry trans-

700388

A3120BE-B.book 9 ページ２００６年５月３０日　火曜日　午前９時３２分

1 2 ... 233 234 235 236 237 238 239 240 241 242 243 ... 400 401

Kommentare zu diesen Handbüchern

Keine Kommentare