Subaru 2007 Tribeca Bedienungsanleitung PDF herunterladen (Seite 329)

11-12 Maintenance and service

T Changing the coolant

Always add genuine Subaru cooling sys-

tem conditioner whenever the coolant is

replaced.

Change the engine coolant and add gen-

uine Subaru cooling system conditioner

using the following procedures according

to the maintenance schedule in the “War-

ranty and Maintenance Booklet”.

1. Remove the under cover.

2. Place a proper container under the

drain plug and loosen the drain plug.

3. Loosen the radiator cap to drain the

coolant from the radiator. Then drain the

coolant from the reserve tank. Tighten the

drain plug securely.

4. Install the under cover.

1) Fill up to here

5. Slowly pour the coolant and fill up to

just below the filler neck, allowing enough

room to add genuine Subaru cooling sys-

tem conditioner in the radiator. Add genu-

ine Subaru cooling system conditioner un-

til the coolant level reaches the filler neck.

Do not pour the coolant too quickly, as this

may lead to insufficient air bleeding and

trapped air in the system.

Coolant capacity (Guideline):

7.8 US qt (7.4 liters, 6.5 Imp qt)

B00310

Never attempt to remove the radia-

tor cap until the engine has been

shut off and has cooled down com-

pletely. Since the coolant is under

pressure, you may suffer serious

burns from a spray of boiling hot

coolant when the cap is removed.

1

B00311

y Be careful not to spill engine cool-

ant when adding it. If coolant

touches the exhaust pipe, it may

cause a bad smell, smoke, and/or

a fire. If engine coolant gets on the

exhaust pipe, be sure to wipe it

off.

y Do not splash the engine coolant

over painted parts. The alcohol

contained in the engine coolant

may damage the paint surface.

A3120BE-B.book 12 ページ２００６年５月３０日　火曜日　午前９時３２分

1 2 ... 324 325 326 327 328 329 330 331 332 333 334 ... 400 401

Kommentare zu diesen Handbüchern

Keine Kommentare